- 37 -
STEP 2
Measure the length of the tube that will connect the CPU to the GPU
water block, and the GPU water block to the pump-reservoir unit. You
can use the EK-Loop Soft Tube Cutter or a pair of scissors to cut the tube.
You may also need additional tubing to connect the water
block.
Attach the tube to both fitting barbs until it sits firmly. Secure the fitting
compression ring to make the assembly is complete. Check again that
all tubing is secured with compression fittings as intended. If it is not,
please see chapter: Connecting the Tubing.
Fill the system by following the Steps from the chapter: Filling
the System for the First Time.
STEP 2
In order to obtain the best performance across
the entire lifespan of the product, it is crucial
to follow these maintenance tips.
1. DUST REMOVAL
It is mandatory to clean the dust every 2-3 months. EK recommends
using a vacuum cleaner or compressed air to blow the dust away.
The radiator is usually the dustiest, so pay special attention to it. Do
not forget to turn off the computer and unplug the power supply. It is
recommended to clean the dust outside.
2. CHECKING THE ELECTRICAL COMPONENTS
Once a year, you should check if the pump and fans are running
as they should. The pump and fans must run silently without any
rattling noises and must react to PWM duty cycle changes. All
imperfections may lead to overheating and, ultimately, breakdown.
3. CLEANING THE UNIT
Every year the unit should be thoroughly cleaned. You must let all
the coolant out (see chapter: Draining the Loop). The radiator must
be flushed, the pump checked and cleaned. It is also recommended
to change the tubing.
4. USING PARTS DESIGNED AND MANUFACTURED BY EK
It is recommended to use only genuine EK Water Blocks liquid cooling
gear and add-ons to prevent any performance, compatibility, or
warranty issues.
MAINTENANCE TIPS
To Next Page
Loading...
