ekwb EK-Quantum 240 - Amd Socket Motherboards

- 16 -
STEP 7
With EK-Velocity series water blocks, it is mandatory to
use the port closest to the center of the water block as the
INLET port. Mixing these ports up may result in poor thermal
performance of the water block.
Tighten the fitting barbs in the clockwise direction until the gasket
underneath is compressed.
STEP 7
Inlet port
Intel® Socket
Mounting Plate
AMD® Socket
Mounting Plate
M4x14
Screws
STEP 1
AMD® SOCKET MOTHERBOARDS
STEP 1
Replacing the Mounting Plate:
Place the water block on an even surface and, using the 2.5mm Allen
key in the counter-clockwise direction, remove four M4x14 DIN 7991
screws attaching the copper base to the top.