ekwb EK-Quantum 240 - Page 17

- 17 -
STEP 2
Replace the Intel® factory-installed mounting plate with the AMD®
one. You will feel the mounting plate locking into position when
placed correctly onto the top.
Reseat the O-ring gasket into the gap between the mounting plate
and water block top.
STEP 3
Removing the Original Plastic Hold-Down Clamps and Factory
Backplate: Using a Phillips head screwdriver, remove four UNC 6-32
screws securing the original plastic hold-down clamps around the
socket, as shown in the image.
Remove the original AMD® backplate along with the hold-down
clamps, and store them away. For further identification of the parts,
see the image on the left.
Orientation of the
Copper Base
STEP 2
AMD® factory backplate
UNC 6-32
Screws
Hold-down
clamps
STEP 3