- 18 -
Metal Backplate
Rubber
gasket
Motherboard
STEP 4
STEP 4
Position the rubber gasket and place the metal backplate for AMD®
socket to the back of your motherboard ribbed side up (facing away
from the motherboard). Align the holes on the motherboard with
holes on the rubber gasket and backplate.
Using one hand, carefully rotate the motherboard assembly with the
front side facing up while holding the backplate and rubber gasket in
place with the other hand.
STEP 5
Prepare the foil bag with the mounting mechanism that is enclosed
with the CPU water block.
Install four (4) M3 thumb screws into your motherboard. It is
mandatory to put 0.7mm plastic washers underneath each of the
M3 thumb screws. Tighten the screws until you reach the end of the
thread. Using tools (i.e., pliers) is not recommended.
M3 Thumb Screw
PVC washer
STEP 5
To Next Page
Loading...
