- 27 -
CONNECTING THE TUBING
If you are adding another unit to your water cooling loop, please
check the chapter System Expansion Possibilities.
STEP 1
In order to successfully route your tubing, we recommend you check
the liquid cooling scheme.
STEP 1
STEP 2
Try to visualize the tube route and then measure its distance by
trying to fit it into the chassis. Mark the required length with a
felt-tip pen.
Before you make the first cut, keep in mind that it’s best to
have 2–3cm in tube length to spare. You can always shorten
the tube afterward.
For the coolant to flow without restriction, make sure the
tube is not bent or twisted.
STEP 2
CPU Water
Block
Radiator
with Fans
COLD AIR
HOT AIR
Reservoir and Water-
Pump Combo
To Next Page
Loading...
