- 26 -
STEP 3
Secure the M4 x 6 screws from the previous Step with four (4) M4 nuts
and PVC washers. Tighten them with a 2.5mm Allen key.
The pump-reservoir unit has clearly marked inlet (˄) and
outlet (˅) G1/4 ports. Not taking that into account will lead
to reverse flow.
STEP 3
STEP 4
Tighten the fitting barbs in the clockwise direction until the gasket
underneath is compressed.
The installation of the pump-reservoir unit is now complete.
OPTIONAL: EK-Quantum Power Kit also comes with two pieces
of EK-Torque 90˚ Angled Fittings, which can be installed on the
Pump-Reservoir Combo unit, CPU unit, or Radiator.
STEP 4
Fitting
Barb
Fitting
Ring
EK-Torque 90˚
Angled Fittings
EK-Torque 10/16
STC Fittings
M4 PVC Washer
M4 Nut
M4 x 8 DIN7984
To Next Page
Loading...
