- 25 -
STEP 1
The EK-Quantum Power Kit comes with a combined pump and
reservoir unit with a pre-installed antivibration holder.
Take the unit and place it on the EK-Loop Uni Pump Reservoir
Bracket, as shown in the picture.
You can turn the pump in any direction, but do not turn it
upside-down.
Secure the pump from the backside using four (4) M4 x 10 screws
and PVC washers. Tighten them in a clockwise direction using the
enclosed 2.5mm Allen key.
This unit can be installed without the use of a pump bracket if there
is a 62 x 34mm rectangular mounting hole pattern in the chassis.
STEP 1
Pump-Reservoir Combo Unit
EK-Loop Uni Pump
Reservoir Bracket
STEP 2
The position of the unit will depend on the fan mounting holes and
hardware that is installed in the chassis. Usually, cases already have
standard pre-drilled fan-mounting holes, and you should look for those
with a spacing of 105mm.
Alternatively, you can drill four Ø4.5mm holes using an electric
power drill in the most suitable place of your computer chassis.
Place four M4 x 6 DIN7984 screws into the holes of the EK-Loop Uni
Pump Reservoir Bracket from its front side.
STEP 2
M4 x 10 DIN7984 Screws
PVC Washers
EK-Loop
Uni Pump
Reservoir
Bracket
Pump-
Reservoir
Combo Unit
M4 x 6
DIN7984
Screws
To Next Page
Loading...
