- 28 -
STEP 3
If you assembled the components according to this installation
manual, all the compression fittings should have already been
installed.
To fit the tubing onto the compression fittings, you will have
to remove fitting rings by rotating them in a counter-clockwise
direction.
STEP 3
STEP 4
Slide the fitting ring along the tube with the threaded side facing
the fitting barb.
Install the tube on the fitting barb. You can do that by forcing it
to slide over the edge as far as it goes. If needed, heat the tube
in warm water.
STEP 4
Fitting Barb
Fitting Ring
Tubing
To Next Page
Loading...
