909 Control Panel Instruction For Swing Gates 230VAC
General safety rules
WARNING: Unskilled personnel should never be allowed to assemble, repair or adjust the devices and all necessary
precautions must be taken to prevent accidents: power supply disconnected (including backup batteries if present).This
product is not suitable for installation in explosive atmospheres.
Keep this handbook carefully, store it attached to the technical installation leaflet in a safe place where it is available
to anyone who may need it and make sure that all involved personnel are aware of this.
Type of product
The control p
anel 909 is suitable to control swing gates (1 or 2 operators) with or without electronic clutch. It is auto-
programmable and provided with an adjustable anti-crushing feature. It is possible to add a timer to the START input to
program openings and closings. It is protected from interferences, lightning and electrostatic events. This control panel has
past all the tests regarding electromagnetic emissions and interferences according to the European standards directive
EMC 89/336/CEE, 92/31/CEE, BT 73/23/CEE e 93/68/CEE.
WARNING: the installation and setting of this control panel has to be done only by qualified persons who respect all the actual norms in the field of automatic entrances as well
as all the information reported on this manuals. In any case, the installer has to check if it is necessary to install a switch or breaker on the power point before wiring the control
panel to the main power supply according to the actual norms. The manufacturer of this control panel can not be responsible for damages or others if the panel is used in a
different way to the one explained in this manual. Protect the device with a 6A switch with suitable fuses and earth protection. Use the provided transformer or a similar one.
Check that ground wire is connected to the right place. Use individual wires and NOT a multiwires cable. If the distance of the wires is longer than 50 m, then install a relay to
control the inputs. All NC inputs must be wired to the input 7 if not used. Minimum diameter is 2,5mm for the wires connecting light and motor. To avoid any interference keep
wires for the inputs separated from those for the outputs.
To Next Page
Need help?
General
