Why elco VG 1.55 Burner does not start with normal gas pressure?
If the Elco Burner does not start, but you have normal gas pressure, it might be due to insufficient gas pressure or a gas pressostat that is wrongly set or defective. To resolve this, check the gas lines, clean the filter, and inspect or replace the gas pressostat or the compact gas unit.
What to do if the Elco Burner switches off during operation?
If the Elco Burner switches off during operation, it could be due to the air pressure switch contact opening during start-up or operation, or a flame failure during operation. You should adjust or replace the pressure switch and check the ionization sensor circuit. Also, check or replace the automatic combustion control unit.
Why elco VG 1.55 Burner does not start after thermostat shutdown?
If the Elco Burner does not start after thermostat shutdown and there's no malfunction indicated on the automatic combustion control unit, it could be due to a drop in supply voltage, a power failure, or a control unit malfunction. Check the cause of the voltage drop or power failure and replace the control unit.
Why Elco Burner blower starts up but burner doesn't?
If the Elco Burner blower starts up, but the burner does not start, it could be because the air pressure switch contact does not close. Inspect the pressure transmitter for foreign bodies and check the wiring.
What to do if elco VG 1.55 starts briefly then switches off?
If the Elco Burner starts briefly when switched on, then switches off and the red LED lights up, it means the control unit was deliberately shut down. Unlock the unit.
What to do if the elco VG 1.55 starts, the ignition switches on, then failure?
If the Elco Burner starts, the ignition switches on, but then there's a failure, it could be due to several reasons, including no flame at the end of the safety period, incorrect gas throughput, a faulty flame monitoring circuit, no ignition arc, short-circuited electrode(s), damaged ignition cable, a defective ignition transformer or automatic combustion control unit, solenoid valves that don't open, or valves jamming. To address this, adjust the gas throughput. Inspect the condition and position of the ionization sensor. Check the condition and connections of the ionization circuit (cable(s) and measurement bridges). Adjust, clean, or replace the electrode(s). Connect or replace the cable(s). Replace the transformer, control unit, or compact gas unit. Also, check the cabling between the ...
Details the operation of the TCG 1xx automatic gas combustion control unit without TC function.
Describes the operational sequence and behaviour of the burner during various states.
Details the safety mechanisms and responses to prevent hazardous situations.
Focuses on operating and safety functions for burners without TC function.
Provides a fault diagnosis table with causes, remedies, and safety component replacement guidelines.
To Next Page
General
