EasyManuals Logo

Elcometer 319/2 User Manual

Elcometer 319/2
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
9
4 TAKING MEASUREMENTS - USING ‘MEASURE’
Follow this procedure to start measuring immediately without logging the results into
your gauge memory. If you want to log results, refer to page 10 and page 13.
1. If required, check the limits for the alarm in the Setup menu (see Limits” on
page 19). When a limit is exceeded during measuring, an audible alarm is
triggered, a red LED flashes and the alarm sign is displayed next to the
parameter concerned.
2. From MENU, scroll to Measure and then press OK.
The gauge starts measuring.
3. Place the rubber tip of the surface temperature sensor against the surface,
preferably at an angle of 90°, and keep it in this position until the measured
value remains stable (the trend indicator [ ] between the parameter and
the reading indicates if the value is increasing [ ] or decreasing [ ]).
When a limit is exceeded, an audible alarm is triggered and the alarm sign is
displayed next to the parameter concerned.
4. If you want to freeze the measurements on the display, scroll to Hold and then
press OK.
To continue measuring again, scroll to Release and then press OK.
Log manual
Log interval
Setup
22/06/07
12:23
RH 72,0 %
Ts 23,2 C
Ta 24,0
Td 18,6
O
O
O
C
C
Menu
Measure
R

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elcometer 319/2 and is the answer not in the manual?

Elcometer 319/2 Specifications

General IconGeneral
BrandElcometer
Model319/2
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals