EasyManuals Logo

Elcometer 319/2 User Manual

Elcometer 319/2
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
17
7.2 INSTALLING ELCOMASTER™ SOFTWARE
1. Place the CD in your PC. The software installation wizard should run automatically. If it does not run
automatically:
Choose Start > Run
Type D:AutoCIS (where ‘D’ is the letter of your CD drive)
Click OK. The software installation wizard will run.
2. Follow the on-screen installation instructions.
Follow the instructions included with ElcoMaster™ to interface your gauge with your PC.
7.3 USING THE DOCK AS A MAGNETIC HOLDER
If the Dock is going to be used as a magnetic holder:
1. Secure the gauge to the Dock by tightening the hexagon head screw into the back of the gauge.
2. Connect the external surface temperature probe supplied with the Dock to the green connector on the
side of the Dock; ensure that the two legs of the connector are in the correct position (note that one leg
is wider than the other). The external surface temperature probe will be displayed as Te when
connected.
3. Press the magnetic probe against the ferrous steel surface.
4. Taking care, place the back of the instrument against the surface, top first, then place the lower part of
the instrument against the surface.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Elcometer 319/2 and is the answer not in the manual?

Elcometer 319/2 Specifications

General IconGeneral
BrandElcometer
Model319/2
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals