R
23
temperature probe is not fitted when Thermometer Mode is toggled ‘on’, the gauge will display an error
reading ‘---’.
Set Limits: Toggles limits on/off and adjusts limits for all measured and calculated parameters.
The Set Limits menu is displayed. Any low and high limit values toggled ‘on’ are listed.
To toggle a limit on/off or adjust its value, scroll to the parameter and press Sel.
To toggle a limit on/off, scroll to High Limit on/Low Limit on and then press Sel.
To adjust a limit value, scroll to the limit and press Sel. Now scroll to the required value and press Ok (press
and hold to adjust values quickly).
When finished, press Back.
View Time & Date: Displays the current time and date.
If required, press Set to change the time and date (see “Time/Date” on page 25).
When finished, press Back.
Setup: Adjustment of gauge operating parameters.
See “Gauge setup” on page 24.
Reset: Resets the gauge to International or USA settings. International settings = DD/MM/YY date format
and metric units; USA settings = MM/DD/YY date format and imperial units.
(Note that reset does not delete or affect the contents of gauge memory)
The Reset menu is displayed.
To reset to International Gauge or USA Gauge, scroll to the required option and press Sel. Press Yes to
reset or No to decline.
To Next Page
Loading...
