R
32
• Be careful not to damage the LCD screen.
• Do not subject the gauge to a strong impact.
• Do not wash the sensor in water or solvents.
• If the surface of the humidity sensor becomes saturated with moisture allow the moisture to evaporate
fully before using the gauge to take measurements.
• To clean the plastic housing of the gauge use isopropyl alcohol (rubbing alcohol) and a soft dry cloth
such as those made to clean eyeglasses.
• Keep the gauge away from extreme heat. If the display is heated above 80°C (176°F) it may be
damaged. This can happen if the gauge is left in a vehicle parked in strong sunlight.
• The gauge is dustproof and waterproof equivalent to IP66 and should not be affected by dust and
moisture under normal conditions, however the gauge must not be submerged in liquids.
• Remove the batteries from the gauge and store them separately if the gauge is to remain unused for a
long period of time. This will prevent damage to the gauge in the event of malfunction of the batteries
Regular calibration checks over the life of the gauge are a requirement of quality management procedures,
e.g. ISO 9000, and other similar standards. For checks and certification contact Elcometer or your
Elcometer supplier.
Your gauge does not contain any user-serviceable components. In the unlikely event of a fault, the gauge
should be returned to your Elcometer supplier or directly to Elcometer. The warranty will be invalidated if
the gauge has been opened.
Elcometer contact details can be found stored in the gauge (Menu>About>Contact) and at
www.elcometer.com
To Next Page
Loading...
