Elcometer 355 - Page 9

R
7
2.5 THE DISPLAY
1. Reading number
2. Reading/menu item/value
3. Service required
4. Rough surface
5. Calibration type
6. Battery condition
7. Units
8. Limits
9. Average/Standard deviation
10. Non-ferrous/Ferrous
2.6 INTERFACE
A data output interface is located on the top of your gauge.
2.7 SELECTING A LANGUAGE
The Elcometer 355 has a number of languages built-in.To select a language, see “Language function” on page 22.
2.8 CHANGING UNITS
Your gauge can display coating thickness in µm
b
(microns), mm, mil and thou.
To change units, press [UNITS].
Note: When units are set to mm, the resolution of the display is such that only 1 µm resolution may be
shown, e.g. 10.8 µm would be displayed as ‘0.011’ mm.
b. µm will not be available as an option on probes which have a range greater than 9999 µm
1 3 4
5
6
789
10
2