Eldes ESIM320 - Universal Output Control; Enable Control from Any Phone Number

20
20 EN
ELDES GATE CONTROLLER ESIM120/320 User Manual v.1.1
11.4. Output Control Conrmation by Call Back
The system can make a phone call conrming that the output control action has been successfully carried out. Once enabled, every output
control action will be followed by a 5-second (by default) ring to the user/administrator phone number that the output control by free of
charge phone call was initiated from.
By default, output control conrmation by call back is disabled. To enable/disable it, please refer to the following conguration methods.
Enable output control
conrmation by call
back
SMS
SMS text message content:
ssss_CALLBACK:ON
Value: ssss – 4-digit SMS password.
Example: 1111_CALLBACK:ON
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
Set call back duration
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
Disable output
control conrmation
by call back
SMS
SMS text message content:
ssss_CALLBACK:OFF
Value: ssss – 4-digit SMS password.
Example: 1111_CALLBACK:OFF
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
11.5. Output Control from any Phone Number
Once an administrator phone number is listed, the system will ignore any incoming calls from a non-listed phone number. To permit/deny
output control by free of charge phone call (see 11. OUTPUTS) from a non-listed phone number, please refer to the following congura-
tion methods.
Enable output control
from any phone
number
SMS
SMS text message content:
ssss_ALLNUM:ON
Value: ssss – 4-digit SMS password.
Example: 1111_ALLNUM:ON
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
Disable output
control from any
phone number
SMS
SMS text message content:
ssss_ALLNUM:OFF
Value: ssss – 4-digit SMS password.
Example: 1111_ALLNUM:OFF
Cong
Tool
This operation may be carried out from the PC using the ELDES Conguration Tool software.
NOTE: The system will accept SMS text messages only from a listed administrator phone number even if output control from any
phone number is enabled.
NOTE: Once the output control from any phone number is enabled, a non-listed phone number user will be able to control outputs C1 and
C2.