ZLX Portable Loudspeaker Series Description | en 13
Electro-Voice Installation manual 2019-05 | 03 | F.01U.319.253
2.4 Quick setup – wireless streaming
Wireless streaming
For ZLX-12BT and ZLX-15BT models, follow these instructions to quickly and correctly pair and
tune your system for wireless streaming from a Bluetooth® enabled mobile device.
To pair the system for wireless streaming, do the following:
1. Using the MASTER VOL knob, turn the output gain LEVEL down to MUTE.
2. Push the MASTER VOL knob.
The DSP Control menu appears.
3. Using the MASTER VOL knob, scroll to STREAMING.
4. Push the MASTER VOL knob to select STREAMING.
The focus moves to the parameters on the right side of the DSP menu.
5. Using the MASTER VOL knob, scroll to PAIRING mode.
6. Push the MASTER VOL knob to select PAIRING.
The setting is saved. The focus returns to the menu items on the left side of the DSP
menu.
7. Within 120 seconds, follow the manufacturer’s instructions on your mobile device to pair
with a Bluetooth® device.
The loudspeaker appears as EV ZLX BT on your mobile device.
Gain structuring
After pairing your mobile device with the system, you can set the volume for your streaming
device.
To set the volume for your streaming device, do the following:
1. Set the loudspeaker output gain to MUTE.
2. Start playing music from your desired player/source.
3. Increase the volume on your mobile device.
The BT VU meter on the ZLX loudspeaker's LCD responds to the incoming signal.
4. Increase the volume from your device until the BT VU meter is ~75% full.
Take note of the volume slider on your mobile device as well: to prevent clipping, do not
go past this level.
5. Using the MASTER VOL knob, increase the output gain to the desired listening level.
Be mindful of the CLIP and LIMIT notifications.
6. Turn the level down on your mobile device for convenient volume control (optional).
To prevent clipping, do not exceed the level previously observed (~75% BT VU).
See also
– DSP controls, page 20
To Next Page
Loading...
