Electrolux BW450 - Fitting a Decor Panel

Fitting a decor panel
Model BW450 is supplied in white with a decor frame around the main door
and lower panel (see Fig. 12). To fit the panel proceed as follows:-
1. Remove the 3 screws on each side and four screws on the lower edge of the
door.
2. Remove the decor panel
3. Cover this panel with a sheet of laminated plastic so that it co-ordinates
with your kitchen.
4. Replace the decor panel and replace the screws in the frame.
The laminated covering sheet should have the following measurements:-
Width 436mm
Height 592mm
Max. Thickness 4mm.