Electrolux BW450 - Location; Connecting to the Mains

In order that your new dishwasher will operate correctly and give you the best
possible results it must be installed in accordance with the following
instructions. Any local regulations concerning connections to the electricity
and water supplies and drainage must also be complied with.
LOCA TION
Your dishwasher can be placed in any suitable position providing the water,
drain and electrical connections are accessible. The machine can be free
standing or placed in a recess providing that adequate ventilation is left for air
circulation. It can be levelled by adjusting the two front feet using a 25mm
spanner. Wherever this machine is placed is must be possible to disconnect
and remove the machine easily should service be required.
Your dishwasher has fill and drain hoses which can be turned either to the
right or to the left (Fig.l) to suit your installation requirements.
Before turning the water supply on, ensure that the connections on all
hoses are secure to avoid the possibility of flooding.
(1) Some of the internal fittings are secured by tape or wire ties; these should
be removed before operating the machine.
(2) If this appliance is replacing an old dishwasher which is to be scrapped,
we would ask your assistance in preventing young children becoming trapped
inside your old machine by ensuring the door is removed before disposal.
(3) Make sure you retain this book and keep it in a safe place for future
reference.
CONNECTING TO THE MAINS
Before you use your dishwasher check that the voltage shown on the data
plate conforms with your mains supply.
The mains lead of the dishwasher is fitted with a non-rewireable moulded-on
13 amp plug containing a 13 amp fuse. In the event of the fuse requiring
replacement, the fuse cover/carrier should be removed, using a small screw
driver to lever it out. The old fuse should be replaced by a 13 amp ASTA
approved BS1362 fuse and the fuse cover/carrier must be refitted before the
plug is used again.