It is normal for a small amount of water to come out of the salt container.
1. The salt container must only be refilled when the salt warning light in the control panel comes on.
Depending on how fully the salt dissolves, the salt warning light may still be on even though the
salt container is filled.
2. If there are spills of the salt, a soak or a rapid program should be run to remove the excess salt.
3. If use Multi-benefit tablets to instead softener function, there may be drop-marks on dishes
after washing, if the water hardness is ＞100mg/L. And should regularly use Machine Care
program to clean the scale in water circulation system with dishwasher specific acidic
chemical.
Always use salt intended for use with dishwasher.
The salt container is located beneath the basket and should be filled as follows:
Attention!
Only use salt specifically designed for use in dishwashers! All other types of
salt not specifically designed for use in a dishwasher, especially table salt, will
salt the manufacturer does not give any warranty nor is liable for any caused
damages.
Only fill with salt just before starting one of the complete washing programmes.
This will prevent any grains of salt or salty water, which may have been split,
remaining of the bottom of the machine for any period of time, which may cause
corrosion.
NOTE:NOTE:
A Remove the basket and then unscrew and remove the cap from the salt container.
B Before first wash, add 1lt. of water in the salt container of your machine.
C Place the end of the funnel (supplied) into the hole and introduce about 1kg of salt.
D After filling the container , screw the cap tightly back clockwise.
E Usually, the salt warning light will be cease to be illuminated within 2-6 days after the salt container has been filled with
salt.
F Immediately after filling the salt into the salt container, a washing programme should be started (Suggest choose
therwise filter system, pump or other important parts of the machine may be damaged by
salty water. It is out of warranty.
(Suggest choose
NOTE:NOTE:
If your model have no water softener, you may skip this section.
8
PRIOR USING FOR THE FIRST TIME
AA..
(fig. )
11
(fig. )
22
Quick
programme). O programme).
damage the water softener. In case of damages caused by the use of unsuitable
Loading the SaIt Into the Salt container
Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which would have a detrimental or adverse effect on the
operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area. Your local Water Authority can advise you on the
hardness of the water in your area.
To Next Page
Loading...
