EasyManua.ls Logo

Electrolux EFC3862MS - Water Outlet; Start of Dishwasher; Troubleshooting Tips; Before Calling

Electrolux EFC3862MS
31 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
into the sink. It will be necessary to drain excess water from hoses into a bowl or suitable
container that is held outside and lower than the sink.
Ensure that the water drain hose is not kinked or squashed.
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning effect of the dishwasher could be reduced.
Water Outlet
Extension Hose
How to Drain Excess Water From Hoses
Start of dishwasherStart of dishwasher
The following things should be checked before starting the dishwasher.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Attention:Attention:
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
3 Inlet hose connections are fully tightened and not leaking
23
If the sink is 1000mm higher from the floor, the excess water in hoses cannot be drained directly
Connect the water drain hose. The drain hose must be correctly fitted to avoid water leakage.
there should be some space when the door is opened.
Before Before CallingCalling for for ServiceService
TROUBLESHOOTING TIPS
Possible Causes What To Do
Fuse blown, or the
circuit breaker tripped.
Replace fuse or reset circuit breaker. Remove any other
appliances sharing the same circuit with the dishwasher
Review the charts on the following pages may save you from calling for service.
Problem
Dishwasher doesn
'
t
start
Closed dishwasher making sure that door latches.
Make sure the dishwasher is turned on and the door is
closed securely.
Make sure the power cord is properly plugged into the
wall socket.
Power supply is not
turned on.
Door of dishwasher
not properly closed.
Water not pumped
from dishwasher
Kink in drain hose
Filter clogged.
Kitchen sink clogged.
Check drain hose.
Check the coarse filter.
(see section titled " Cleaning The Filter ")
Check kitchen sink to make sure it is draining well.
If problem is kitchen sink not draining ,you may need
a plumber rather than a serviceman for dishwasher.
Technical
problems

Related product manuals