Detergents with its chemical ingredients are necessary to remove dirt, crush dirt and transport it out of the dishwasher.
Most of commercial quality detergents are suitable for this purpose.
C. Function of DetergentC. Function of Detergent
Adjusting Rinse Aid Dispenser
The rinse aid dispenser has four settings.The recommended setting is on "3".
If the dishes still are not drying properly or are spotted, adjust the dial to the
next higher number on "4".
Increase the dose if there are drops of water or lime spots on the dishes after washing.
Reduce it if there are sticky whitish stains on your dishes or a bluish film on glassware or
knife blades.
Adjust lever
(Rinse)
Adjust lever
(Rinse)
NOTE:NOTE:
MAXMAX
10
At tention !
Only use branded rinse aid for dishwasher. Never fill th e rinse aid dispenser wit h any othe r substances
(e.g. Dishwasher cleanin g agent , liq uid detergent) . This would damag e th e applia nce.
When to Refill the Rinse Aid Dispenser
1
2
3
during the next wash. Don't forget to replace the cap before you close dishwasher door.
To open the dispenser, turn the cap to the "open" (left) arrow and lift it out.
Pour the rinse aid into the dispenser, being careful not to overfill.
Replace the cap by inserting it aligned with "open" arrow and turning it to the closed (right) arrow.
NOTE:NOTE:
Clean up any rinse aid split during filling with an absorbent cloth to avoid excessive foaming
As the rinse aid diminishes, the size of the black dot
on the rinse aid level indicator changes, as illustrated below.
Full
3 / 4 ful l
1 / 2 ful l
1 / 4 full - Should refill to eliminate spotting
Empty
C (Rinse-Aid indicator)
1
2
3
When the rinse-aid container is full, the whole
of the dark dot decreases. You should never let
the rinse aid get below 1 / 4 full.
You can judge the amount of rinse-aid by the color
of the optical level indicator C located next to the cap.
indicator will be dark .As the rinse-aid diminishes, the size
To Next Page
Loading...
