WARNING!WARNING!
If overflow occurs, turn off the main water supply before calling a service.
If there is water in the base pan because of an overfill or small leak,
the water should be removed before restarting the dishwasher.
nn
nn
The dishes
are not drying
Re-loading the dishes properly.
Load the dishwasher as suggested in the directions.
Increase the amount of rinse-aid/Refill the rinse-aid
dispenser.
Do not empty your dishwasher immediately after
washing. Open the door slightly so that the steam can
escape. Begin unloading the dishwasher only once t
he dishes are barely warm to the touch. Empty the low
basket first. This prevents water form dropping off
dishes in the upper basket.
In short programmes the washing temperature is lower.
This also lowers cleaning performance. Choose a
programme with a long washing time.
Water drainage is more difficult with these items.
Cutlery or dishes of this type are not suitable for
washing in the dishwasher.
Dishes block
detergent cups.
Improper loading
Too little rinse-aid
Dishes are removed
too soon.
Wrong programme
selection
Using cutlery with
a low-quality coating
Unsatis
-factory
drying
result
If the door can’t open automatically after
washing(except Pre-rinse and Quick). Inspect
that if any physical barrier keeps the door from
opening. Or there is something wrong with the
auto door
open component. Please contact the
after sale service.
Fault of auto door
open.
Error Codes
If there is a malfunction the dishwasher will display an error code. The following table
shows possible error codes and their causes.
Codes
Meanings
Possible Causes
Longer inlet time.
Faucets is not opened, or water intake is
restricted,or water pressure is too low.
E1
E3
Not reaching required
temperature.
Malfunction of heating element.
E4
Overflow.
Some element of dishwasher leaks or the
water can’t drain.
Failure of communication
between main circuit board
with display circuit board.
Open circuit or break wiring for
the communication
Ed
To Next Page
Loading...
