7
3. Warnings
• Any work on Electrical Appliances must be carried out by a qualified professional.
• Confirm that the Power System is operational before working on the Appliance.
• Check that the Appliance is restored to its original safety condition after the operation is complete.
• Take the plug out of the socket to disconnect the power supply before you access internal components. This
platform is not fitted with an ON / OFF switch.
• The Sensors located on the display board could be at a potential of 220 Volts (If applicable).
• Replace the heating element with the one that has the same characteristics (2
thermal fuses) to maintain safety measures for the Appliance. Do not remove / switch
the NTC sensors between heating elements (See Figure).
• Always empty the Appliance before laying it on its side for any servicing.
• Do not lay down the machine on Electronic Control System side while servicing the
unit. In such cases, some water in the detergent dispenser could sip into the electrical
/ electronic components and cause these to burn.
• The resistance values of the components shown in this SM (Service Manual) are purely
indicative and approximate.
• Do not place any container under the Appliance to avoid collecting drops of water.
• Always place the cotton cloth below the machine to absorb water. There is a possibility of water leakage
while servicing the Pumps and Dispenser.
Heating Element with
Different Characteristics
To Next Page
Loading...
