Electrolux EOB 6790 - Initial Oven Setup; Setting the Oven Clock; Selecting the Display Language

6
!
When the Oven is First Installed
When the oven is first connected to the electrical supply,
or when supply is restored after a long power failure, the
upper section of the display shows this message:
"WELCOME TO * KRONOS-3 * BASIC -2 * DANSK *
DEUTSCH * ENGLISH * ESPANOL * FRANCAIS *
ÅËËÇÍÉÊÁ * ITALIANO * NEDERLANDS * NORSK *
PORTUGUES * SVENSKA * ÐÓÑÑÊÈÉ"
This message lists all the languages which can be chosen
to operate with the Oven Electronic Control (Fig. 1).
Symbol flashing near the "Clock Symbol" means
that you need to set the current time of day before using
the oven.
To set the Correct Time of Day
1. Press the "Time Function Button" . While symbol
flashes near the "Clock Symbol" , set the
current time of day pressing buttons or (Fig.
2). Once you have set the time, the symbol keeps
flashing for 5 seconds and then disappears. This
means that the setting has been stored in the
Electronic Control memory.
2. If symbol stops flashing before you have had time
to set the clock, press the "Time Function Button"
twice. The symbol starts flashing again.
Then, proceed as described at point 1.
!
To Select the Language
You can choose the language to be used in the Oven
Electronic Control display.
The oven must be OFF when carrying out this operation.
1. Press the "Cooking Function Button" and the
"Recipe Selection Button" at the same time and
keep them pressed for 2 seconds at least. The
Electronic Control beeps once and the display shows
the current language selection. (Fig. 3).
2. Within 5 seconds, press button to select your
language (Fig. 4).
3. Once you selected your language, you have 5 seconds
to confirm your selection by pressing the "Cooking
Function Button" and the "Recipe Selection Button"
at the same time and keeping them pressed for 2
seconds at least.
Please note that anytime you carry out a step of
this procedure, you have 5 seconds to carry out the
following step. If you wait more than 5 seconds the
Electronic Control switches off and the selection is
not stored in its memory.
Here follows the list of available languages:
Danish (DANSK), German (DEUTSCH), English
(ENGLISH), Spanish (ESPANOL), French (FRANCAIS),
Greek (ÅËËÇÍÉÊÁ), Italian (ITALIANO), Dutch
(NEDERLANDS), Norwegian (NORSK), Portuguese
(PORTUGUES), Swedish (SVENSKA) and Russian
(ÐÓÑÑÊÈÉ).
Fig. 2
Fig. 3
Fig. 4
Fig. 1