electrolux 33
Stainless steel or aluminium
appliances:
We recommend that the oven door is only
cleaned using a wet sponge and dried after
cleaning with a soft cloth.
Never use steel wool, acids or abrasive
products as they can damage the oven
surface. Clean the oven control panel
following the same precautions.
Clean the oven door with lukewarm water
and a soft cloth. Do not use products such
as scouring pads, steel wool, abrasive
sponges or acids because they could
damage the special heat-reflecting sur-
face of the internal panes of glass.
After cleaning, reassemble the panes in the
door and then the oven door, following the
procedure described above in reverse. Make
sure you reposition the panes correctly.
To perform this operation correctly,
proceed as follows:
a) the clear innermost pane must be reas-
sembled so that the screen-printed sym-
bol in one corner is placed in the upper left-
hand corner as shown in Fig. 38a.
The pane must be put back into the right
seat as shown in Fig. 38b.
b) the decorated internal pane with a frame
on the four sides must be reassembled
so that the screen-printing is facing out-
wards. The side of the pane of glass is
correct if you do not feel any roughness
near the screen printing when you pass
your fingers over the surface.
The pane of glass must be put back into
the right seats as shown in Fig. 39.
After the panes of glass has been reas-
sembled in the oven door, perform the pro-
cedure described in point 8. in reverse to
ensure it is locked.
Fig. 38b
Fig. 38a
Fig. 39
DO NOT clean the oven door
while the glass panels are warm.
If this precaution is not
observed the glass panels may
shatter. If the door glass panels
become chipped or have deep
scratches, the glasses will be
weakened and must be replaced
to prevent the possibility of the
panel shattering. Contact your
local Customer Care
Department who will be pleased
to advise further.
To Next Page
Loading...
