Problem Possible cause Remedy
The oven does not heat up. The necessary settings are not set. Make sure that the settings are cor‐
rect.
The oven does not heat up. The automatic switch-off is activa‐
ted.
Refer to "Automatic switch-off".
The oven does not heat up. The Child Lock is on. Refer to "Using the Child Lock".
The oven does not heat up. The fuse is blown. Make sure that the fuse is the cause
of the malfunction. If the fuse is
blown again and again, contact a
qualified electrician.
The lamp does not operate. The lamp is defective. Replace the lamp.
The display does not show the time
during the off status.
The display is deactivated.
Touch and at the same time
to activate the display again.
The food sensor does not operate. The plug of the food sensor is not
correctly installed into the socket.
Put the plug of the food sensor as
far as possible into the socket.
It takes too long to cook the dishes
or they cook too quickly.
The temperature is too low or too
high.
Adjust the temperature if necessary.
Follow the advice in the user man‐
ual.
Steam and condensation settle on
the food and in the cavity of the
oven.
You left the dish in the oven for too
long.
Do not leave the dishes in the oven
for longer than 15 - 20 minutes after
the cooking process ends.
The display shows "C2". You want to start the Defrost func‐
tion, but you did not remove the
food sensor plug from the socket.
Remove the food sensor plug from
the socket.
The display shows an error code
that is not in this table.
There is an electrical fault.
• Deactivate the oven with the
house fuse or the safety switch
in the fuse box and activate it
again.
• If the display shows the error
code again, contact the Custom‐
er Care Department.
The descaling procedure is interrup‐
ted before it finishes.
There was a power cut. Repeat the procedure.
The descaling procedure is interrup‐
ted before it finishes.
The function was stopped by the
user.
Repeat the procedure.
There is no water inside the grill- /
roasting pan after the descaling pro‐
cedure.
You did not fill the water drawer to
the maximum level.
Check if the a descaling agent / wa‐
ter is present in the water drawer
body.
Repeat the procedure.
There is dirty water on the bottom of
the cavity after the descaling cycle.
The grill- / roasting pan is on a
wrong shelf position.
Remove the residual water and the
descaling agent from the bottom of
the oven. Put the grill- / roasting pan
on the first shelf position.
The cleaning function is interrupted
before it finishes.
There was a power cut. Repeat the procedure.
ENGLISH 47
To Next Page
Loading...
