Electrolux EOB7S31V - Troubleshooting; What to do if...

Before you replace the lamp:
Step 1 Step 2 Step 3
Turn off the oven. Wait until the
oven is cold.
Disconnect the oven from the
mains.
Put a cloth on the bottom of the cav‐
ity.
Top lamp
Step 1 Turn the glass cover to remove it.
Step 2 Remove the metal ring and clean the glass cover.
Step 3 Replace the lamp with a suitable 300 °C heat-resistant lamp.
Step 4 Attach the metal ring to the glass cover and install it.
Side lamp
Step 1 Remove the left shelf support to get ac‐
cess to the lamp.
Step 2 Use a Torx 20 screwdriver to remove
the cover.
Step 3 Remove and clean the metal frame and
the seal.
Step 4 Replace the lamp with a suitable
300 °C heat-resistant lamp.
Step 5 Install the metal frame and the seal.
Tighten the screws.
Step 6 Install the left shelf support.
13. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
13.1 What to do if...
Problem Possible cause Remedy
You cannot activate or operate the
oven.
The oven is not connected to an
electrical supply or it is connected
incorrectly.
Check if the oven is correctly con‐
nected to the electrical supply (refer
to the connection diagram if availa‐
ble).
The oven does not heat up. The oven is deactivated. Activate the oven.
The oven does not heat up. The clock is not set. Set the clock.
46 ENGLISH