Electrolux FGCD2456QW User Manual

16
“iE0” – family: flow controller problem
“iE0” – code: flow control position (spray arm level)
• The error is stored and displayed only in service mode; there is a new control for each new phase.
• The error is signalled if the desired position of the flow controller is not reached after 120 seconds; the
heating element is deactivated.
• If the signal from the flow controller does not change after 15 seconds, the software suspends the
positioning for 2 seconds and resumes after another max 120 seconds.
“iF0” Code - family: water level problem
“iF0” – Code: overfilling detected
• The error is stored and displayed only in service mode; the program continues.
• The error situation is recognized when the total filling times exceed the limits.
• The times are accumulated at each subsequent filling and reset every time the drain is activated.
• If the error is detected, the heating element is not activated and the subsequent fillings are ignored.
“iF1” – code: high water level
• The error is stored and displayed only in service mode.
• The error condition is recognized if the safety water level is exceeded for more than 4 seconds.
• A drain phase is activated until the water level drops below the safety level.
• The washing program continues only if this condition is achieved
SERVICE
ERROR
CODE
REASON
UNIT REPSONSE
INDICATION DURING
FAILURE
CHECK WHEN FAILURE APPEARS.
i00
PCB Failure
UI or PCB
Loose Connection
User interface will be
OFF.
1. Check main power supply
2. Check UI and PCB connections
i10
A low fill has been
detected.
Cycle will pause
requiring user to
restart.
1. Water tap or Main water supply OFF?
2. Electrical connection of water valve.
3. Blocked water or pinched water supply line.
i20
Slow or no drain
problem.
Cycle will pause
requiring user to
restart.
1. Check and ensure filter is clean.
2. Check for buildup of soils in sump.
3. Ensure check vavle is functioning properly.
4. Make sure that the drain pump is not blocked
and operating normally.
5. Check drain hose Installation and for any
obstructions.
6. Check for a pinched or blocked drain hose.
7. Check that the knockout plug on the disposer
was removed during installation.
4.4 List of Error Codes

Electrolux FGCD2456QW Specifications

General

Brand	Electrolux
Model	FGCD2456QW
Category	Dishwasher
Language	English