ELEGOO ChiTu Box
Other operations:
1)Long press the left click and drag the model to the position you want.
2)Scroll the mouse wheel to zoom in or zoom out the model.
3)Long press the right click to see different perspectives of the model.
3 ChiTu Box Setting
3.1 Click “Parameter Settings” and choose
ELEGOO Mars 3 as your default printer.(See picture 10)
3.2 Build Volume
The below are the default parameters and you don’t need to change them. If the model is bigger
than printer build volume you would need to change its size with ratio locked.(See picture 10)
（Picture 10） （Picture 10）
To Next Page
Loading...
