Need help?Do you have a question about the Elegoo MARS 4 Series and is the answer not in the manual?
Steps for preparing the printer and adjusting the build platform.
Setting the Z-axis zero position and testing projector.
Executing a test print to verify functionality.
Instructions for cleaning printed models and the resin tank.
General| Layer Thickness | 0.01-0.2mm |
|---|---|
| Connectivity | USB |
| Power Input | 100-240V 50/60Hz |
| Operating Temperature | 0 - 40°C |
| Operating Humidity | 20%-80% |
| Slicing Software | Chitubox |
| Supported File Formats | STL, OBJ |
To Next Page