Need help?Do you have a question about the Elegoo Neptune 4 and is the answer not in the manual?
General| Build Volume | 225 x 225 x 265 mm |
|---|---|
| Printing Speed | Up to 500mm/s |
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Extruder Type | Direct Drive |
| Maximum Nozzle Temperature | 300°C |
| Maximum Bed Temperature | 110°C |
| Display | 4.3-inch Touchscreen |
| Power Supply | 350W |
| Supported Filaments | PLA, TPU, PETG, ABS |
| Connectivity | USB, Wi-Fi |
| Bed Leveling | Automatic |
Addresses stepper motor, movement, and belt problems causing noise or abnormal motion.
Covers nozzle clogs, poor adhesion, warping, layer misalignment, stringing, and ringing.
Guides through connecting the base unit and attaching the gantry frame.
Details installing the screen components, filament detection sensor, and cable clamp.
Explains mounting the rear cooling fan and verifying power supply voltage.
Covers nozzle height calibration using A4 paper and 4-corner adjustments.
Explains the 36-point auto-leveling process and Z-axis compensation.
Outlines steps to install the ELEGOO Cura slicer software from the USB drive.
To Next Page