Elegoo Neptune3 - Screen Firmware Update Log; Screen Firmware Version Display

ELEGOO Support：3dp@elegoo.com
- To solve the problem that the Z-offset adjusted during printing will not be saved：
During printing, click 【stop】→【confirm】 or click 【confirm】 after printing is
completed, the Z-offset value will be saved automatically.
Screen firmware
Update log：
20220711：
Added 【Leveling Temperature Settings】 to 【Settings】
20220816：
Added screen firmware version display.【Settings】→【About Machine】：
You can view the motherboard firmware version and screen firmware version.