103
CAB0281-0
Use instructions
3.4.2 Connection to telemetry
This connection allows remote control through a device especially designed for that
purpose.
The telemetry unit performs the energy backup for the continuous operation of the
modem and is equipped with all the utilities for the general control of the parameters
of other equipment and the work station.
To telemetry connection a cable (ELENOS code CAB0281-0) must be inserted into
“EIA485” connector, DB9, on the rear panel of exciters and combiner.
This cable is supplied with the telemetry unit.
The connection can also be made when the machine is operating.
For further information please refer to the telemetry unit manual.
To Next Page
Loading...
