57
3 Use instructions
Use instructions
3.1 User interface
3.1.1 Control unit user interface
The controls and display views of the control unit (representing the combined system
interface as a whole) are described below.
Please note that in order to have complete visibility of all the available interfaces, the
equipment must be set to LOCAL mode and it must be accessed with the specific
passwords.
Specifically in REMOTE mode you lose visibility of the menus 485 SPEED SET, COM.ID LC/
RT DISP MODE, TEMPERATURE UNIT, MAX REFLECTED POWER SWR FOLDBACK SETTING, NO
MAINS AARM SETTING, UPS SETTINGS, GSM/MODEM menu.
Turn the encoder to navigate through the menu items.
To enter the desired item or to access a sub menu press the encoder while on the “>”
icon.
To exit an item press the encoder while on the “<” icon.
If you change the value of a parameter, to maintain it, before turn off the machi-
ne wait at least 60seconds.
In the case of systems without control UNIT (ET5000, ET3500, ET2500) should be taken
as reference the interfaces of the amplifier and the modulator.
Warning: the screen pictures shown below and the values attributed to the parameters
are provided for illustrative purposes only. The parameters shown may vary slightly
according to the equipment and setup type of the audio board.
To Next Page
Loading...
Need help?
General
