4.3
very easy to see, if a component is broken/burned. If you find the micro swit-
ches are malfunctioning, it is possible to order new ones from Eletta Flow
or your representative and replace them on site.
If you need to order a complete Monitor or a Control Unit for any reason, ple-
ase check the identification plate/tag and write down the serial number, flow
range and liquid and order a new Unit from us. We will ship you the complete
Control Unit with diaphragm housing and you can then easily fit the new
Control Unit to your existing Pipe Section with only four (4) screws, (please
see section 2.5 for details).
Spares
We are proud to say that our Flow Monitors are well known for their long life-
time and robust construction but inevitably, it is sometimes needed to order
spare parts. We refer to section 7 where you can find an exploded drawing
showing all replaceable components included in the Flow Monitor.
If you have installed the Eletta S-series Flow Monitor in a very critical appli-
cation, we recommend you to have a complete identically precalibrated
Control Unit on stock, as it will only take removal of four bolts to change this.
The Pipe Section consists of no moving parts and all copper alloy/steel mate-
rial and it is very rare with a break down of this part.
4
To Next Page
Loading...
