14
and/or forfeit the product.
Do not use this product for purposes prohibited by law. Doing so may cause you to
be subjected to fine, be arrested, and/or forfeit the product.
■ Normal maintenance
Do not clean this product with strong solvents, such as thinner and benzene. Doing
so may cause malfunction.
Wipe with a dry soft cloth.
When this product is splashed with detergent, soap, hot spring, bath additive, sun
oil, sun screen, etc., wipe it off with a dry cloth immediately.
■ Luminescent spot and black spot
This product uses a CMOS area image sensor composed of numerous pixels, and
some of the pixels may not operate normally. Therefore, luminescent spots or black
spots could be witnessed on the output screen. This is not a defect but a
phenomenon peculiar to a CMOS area image sensor.
■ Change of SSID and Key
It is recommended that you change your SSID and Key to avoid other people from
using your connection without permission. The SSID and Key can be reset to
factory defaults.
■ Recorded files
This product is composed of precision electronic parts and components. If this
product is handled as follows, the internal data of the microSD card could be
destroyed:
- The microSD card is dislodged, or power is turned OFF while this product is in
operation.
- The supplied USB cable comes out during communication.
Under those circumstances, ELMO shall not be liable for any damages due to
corruption of or loss of the recorded data.
■ microSD card
When using the microSD card other than supplied, format it with this product before
starting to use. Do not use any other device to format. Depending on the
manufacturer and type, some microSD card may not be used even after formatting
To Next Page
Loading...
