Elmo QBiC MS-1 - Resetting the Camera; Forcing the Camera to Turn Off; Resetting to Factory Default Settings

36
RESETTING THE CAMERA
FORCING THE CAMERA TO TURN OFF
In case that the camera cannot be turned off or does not accept any operation, you can
force the camera to turn off by pressing the Power Switch for over 10 seconds. All the LEDs
will turn off.
RESETTING THE CAMERA TO FACTORY DEFAULT SETTINGS
You can reset the camera to factory default settings by pressing the Recording Switch and
the WiFi Switch together for over 5 seconds. All the LEDs will flash green and the camera
will automatically restart.
Default settings of the camera
Item
Default setting
Horizontal angle of view
185°
White Balance
Auto
Self-timer
OFF
WDR
OFF
Exposure
±0
Resolution
1080p / 30fps
Light Metering
Center-weighted
Distortion Correction
OFF
Hand-Shake Correction
OFF
Image Rotation
OFF
Photo Recording Mode
Single
Burst Recording Interval
60fps: 10 frames
Interval Recording Time
00:00:30
Recording Setting
Level： 5, Balance：0
Auto Power OFF
120 seconds
Streaming Setting
MJPEG
WiFi Auto-OFF
ON
Camera AP mode
SSID & KEY : Numbers on the back of the camera