Powering ON
Press and hold (over 1 second) the Power Switch to power on the camera.
The Power LED turns blue.
Powering OFF
Press and hold (over 2 seconds) the Power Switch to power off the camera.
All the LEDs turn off.
(When the camera is connected to a computer via USB cable or the power is supplied by the
optional AC adapter, charging will start after the camera is turned off and the Power LED will
turn red.)
* The camera automatically turns off when the following abnormalities occur:
‒ The temperature inside the camera has exceeded the limit of normal operating
temperature.
‒ An error has been found with the built-in battery.
It is recommended that you change your SSID and Key to avoid other people from using
your connection without permission. The SSID and Key can be reset to factory defaults.
Refer to the following page for details about how to change SSID and Key.
P.43 Settings
To Next Page
Loading...
