General installation requirements
2.40 Installation and connection of the system
Due to the same colors of the cables, do not cut the system
cables as this may cause damage.
Mount all the wires on the distance from electric interference
sources: ignition coils, high voltage spark cables and so on.
Find the ideal point by placing the unit and organizing the wiring
on the particular motorcycle, a procedure must be followed for
the system to function properly.
Make sure the system wires are not in touch with the
motorcycle movable parts, such as pedals, steering gear and
so on.
Check the spaces and construction of the motorcycle, to decide
what is the best available space for mounting the unit and
accessories.
Before installation, make sure all the motorcycle equipment
and circuits, to which the systems to be connected, are in good
condition and no any original equipment errors are indicated.
Cables cut from the system connectors, will VOID the warranty.
Aſter installing the system, activate the built-in backup battery
of the system.
24
To Next Page
Loading...