You can adjust the shock and tilt sensors using
the LCD remote control.
2.21 SHOCK SENSOR SETTINGS
2.20 SENSORS SETTINGS
The adjustment of the shock sensor is performed
in disarmed mode in the following order:
Turn IGNITION to ON position.
1
2
Press and hold button 4
on the LCD remote for 5sec.
3
Press remote button 1
There are five levels. One siren beep means the first level (the
lowest sensitivity) five siren beeps, means the fiſth level (the
highest sensitivity).
To increase >the sensitivity level by (1) one step each time, the
LCD transmitter will respond with sounds and the corresponding
number will appear at the bottom of the screen (max level is 5)
(Factory setting level number 3)
The siren will respond with 3 sounds on the
LCD screen, the shock icon will appear and
the number 3 at the top of the screen.
11
To Next Page
Loading...