Step Action Display
6 Press the Down button twice (x 2)
7 Press the Defrost button twice (x 2)
8 The EMS display shows:
9 Press the Down button to scroll to the half re-set menu:
10 Re-enter the menu entry password:
11 Press the Set button four times (x 4)
12 Press the Up button once (x 1)
13 Press the Down button twice (x 2)
14 Press the Defrost button twice (x 2)
The controller should reset and begin the power-up sequence.
4.12 Statistics
Depending on the model, EMS controllers start gathering a variety of statistics when first powered
up.
Statistics provide information on the following, dependent on firmware:
l Activity: Average number of motion counts and door openings.
l Compressor: Average number of compressor cycles and total compressor runtime.
l
Operation: Settings of the activity frequency (AF) parameter and the saving temperature
disable (PEr) parameter.
l Temperature: Lowest, highest, and average temperature measured on the appliance sensor.
Note:
l A full reset clears all the gathered statistics.
l Please see the following list which describes the statics available to view on your controller model.
4.13 How to view statistics
To view the statistics, press the Up and Down buttons simultaneously.
30 of 86
27 February 2014
To Next Page
Loading...
Need help?
General
