To Next PageTo Next Page
Need help?Do you have a question about the EM TEST compact NX5 bsp-1-300-16 and is the answer not in the manual?
General| Brand | EM TEST |
|---|---|
| Model | compact NX5 bsp-1-300-16 |
| Category | Laboratory Equipment |
| Language | English |
Describes the intended use and application of the compact NX5 test system.
Specifies the designed purpose and application standards for the compact NX5.
Defines the operator's duties and responsibilities for safe operation.
Highlights general hazards associated with high voltages and proper grounding.
Provides essential safety guidelines for installing and initially operating the test system.
Details installation requirements, including protection class and grounding.
Explains the critical grounding and power connection procedures for safe operation.
Details how to connect the system to the ground reference plane for burst tests.
Guidance on connecting and managing the EUT power supply and switches.
Discusses fault current protection and circuit breaker protection for safe operation.
Procedure for updating the NX generator with a new software version.
Steps for updating the SysOS, including saving settings and rebooting.
Guide to saving current device settings to a USB stick before software updates.
Procedure for restoring device settings from a USB stick after a SysOS update.
Instructions for performing a manual firmware update using a USB stick.
Details the various test phenomena supported by the compact NX5 and their icons.
Explains how to adjust parameters for different test phenomena using the wheel and touch screen.
Describes the SET and TEST screens and the state machine during test execution.
Explains the interface for setting up and running tests, including the test and run windows.
Guides the user through setting up the EUT and its power supply configuration.
Configuration of EUT supply, coupling, and phase filter settings for various tests.
Step-by-step guide to adjusting variable transformers for optimal output.
Procedure to adjust tapped transformers using analog DC control voltage.
Technical data for EFT Burst testing according to IEC 61000-4-4.
Technical specifications for Surge Immunity testing as per IEC 61000-4-5.
Technical data for Pulsed Magnetic Field testing according to IEC 61000-4-9.
Technical specifications for Power Fail Generator tests according to IEC 61000-4-11.
Explains the operation of the Burst menu and its different test routines.
Selectable preprogrammed standard test routines for Burst testing.
Offers various useful tests for Burst testing and development.
Defines test levels for Burst testing based on output voltage and coupling configurations.
Guidelines for setting up Burst tests, including ground plane connection and cable decoupling.
Specific setup requirements when using a capacitive coupling clamp.
Explains the operation of the Surge menu and its different test routines.
Selectable preprogrammed standard test routines for Surge testing.
Sets current peak limiters to stop surge tests when current exceeds a threshold.
Explains the operation of the Magnetic Field menu for pulsed magnetic field tests.
Describes test setups for voltage dips and interruption tests using variacs or transformers.
Explains the operation of the Power Fail menu for voltage dips and interrupt tests.
Selectable preprogrammed standard test routines for Voltage Dips and Interruptions.
Offers extended test options for Voltage Dips and Interruptions.
Details voltage variation testing procedures controlled by external sources.
Explains how voltage interruptions are simulated in different operating modes.
Describes voltage dips and variations, including control via variacs.
Explains the operation of the Magnetic Field menu for power frequency magnetic field tests.
Explains the operation of the Telecom Surge menu and its test routines.
Selectable preprogrammed standard test routines for Telecom Surge.
Offers extended test options for Telecom Surge testing.
