EM TEST esd NX30 - Counter

EM Test esd NX30
Instruction Manual V 1.00.7 18 / 33
6.3.4 Counter
Use the counter button to branch into the corresponding menu. Choose the counter mode: Preset counter on / off. In the On
state the counter content can be set. When the simulator is in operation the preset counter counts down until it reaches 0,
which then terminates the selected test sequence.
Reset counter sets the counter content to 0 or it reloads the preset counter with the previously selected value.
Pulse release behavior
Four modes of triggering are supported:
• Press to Start, Press to Stop
• Press to Start, Release to Stop
• Single (on Press)
• Single (on Release)