EM TEST esd NX30 User Manual

EM Test esd NX30
Instruction Manual V 1.00.7 21 / 33
6.3.8 Settings
This further branches into a range of submenus, thus:
6.3.9 Program
Shows all the details of the currently selected settings in the "Actual" state. These values can be saved in one of the eight
memory places by pressing store. Alternatively, a previously saved set of values can be recalled using the wheel in the
actual program. Touching OK loads the selection ready for execution.
6.3.10 Activity Log
An activity log is provided, allowing the user to scroll through the tests shown in hours and minutes before the present.
Changing the relevant test parameters will cause a new entry into the log to be created.
NOTE
The Log is in volatile RAM and will be saved each time the gun is switched off or goes to sleep.
Please switch off the gun properly, simply cutting the power to the esd NX30 can result in loss of data.
6.3.11 Language
Touch the button and choose the language you wish to use with the wheel.
6.3.12 Device info
Gives information separately for the pistol and the base, including:
• Firmware version of the base station and pistol
• Life of the generator
o The number of times the contact discharge switch (in the pistol) was activated
o The total operating hours (uptime)
• Calibration information
o Date of the last calibration
o The calibration certificate number

EM TEST esd NX30 Specifications

General

Brand	EM TEST
Model	esd NX30
Category	Test Equipment
Language	English