it outside the side discharge chute.
Fit the pin in the holes on the
and on the side discharge
chute, so that it passes through the coils
and the drilled end
Insert the cotter pin in the pin
hole and rotate the pin
.
Check that the spring works
correctly and keep the side discharge
chute securely lowered. Make sure that
the pin is fitted properly to prevent
it from falling out accidentally.
For models with optional
side unloading: make sure that the side
unloading guard (Fig. 13.A) is lowered and
locked by the safety lever (Fig. 13.B).
Before disassembling or
servicing the deector, always push the safety
lever (Fig. 14.B) and lift the side unloading
guard (Fig. 14.A) to allow disassembly.
NOTE To remove the deector, perform
assembly steps in reverse order.
The machine
on, turn the lights on by turning
are enabled..
starter motor to start the machine.
according to the engine type:
command
The positions indicated correspond to:
To Next Page
Loading...
