Action
the speed change is
The engine stops
The engine stops
If any of the results fails to match the
indications provided in the tables, do not
use the machine! Contact a service centre to
have it checked and repaired if necessary.
Always bear in mind that
the safety devices prevent the engine from
starting if safety requirements have not
been met. In these cases, once the start
consent has been reinstated, the ignition
key (g. 10.A) must rst be turned back to
Of before the engine can be restarted.
•
obstacles (such as stones, branches, roots,
• Do not stop or start suddenly
•
particular attention to
• Reduce speed:
–
and during tight turns
–
•
especially on slippery ground.
•
standstill and unattended.
•
the machine at a standstill and unattended.
• For models with hydrostatic drive
only:
Sit in the operator’s position.
engage the
it to Start to start the engine.
the engine has started.
as soon as the
NOTE Using the choke when the engine
is already warm can foul the spark plugs
and cause the engine to run erratically.
the throttle control to the minimum
NOTE If there are engine starting problems,
do not insist as you can risk running the
battery at and ooding the engine. Turn
the key to the O position, wait for a few
seconds and then repeat the operation. If
the malfunction persists, refer to the engine
manual and chapter «14» in this manual.
To Next Page
Loading...
