- the cutting means engage
and disengage functions
- switching the drive to forward
or reverse gears.
The cutting-means assembly should be properly
Cutting means
A badly sharpened cutting means pulls at the
All work on the cutting means
(disassembly, sharpening, balancing,
repairing, reassembly and/or replacing)
are demanding jobs that require special
skills as well as special tools. For
safety reasons, these jobs are best
carried out at a Specialised Centre.
Make sure damaged, misshapen
or worn cutting means are replaced
as a whole unit, together with its own
screws in place to preserve balance.
Cutting means should
be replaced in pairs, especially when
there are marked dierences in wear.
Always use original
cutting means bearing the code
indicated in the “Technical Data”.
Use a suitable lifting
device, for example a scissor jack.
to complete some preliminary operations:
•
• Position the machine on a solid
•
•
•
•
•
perpendicular to the ground.
•
•
•
•
NOTE In this position the jack allows you
to only raise the wheel to be changed.
NOTE The wooden wedge prevents
damage to the front axle.
rests against the chassis and
NOTE During this phase use your hand to
keep the wedge balanced correctly on the jack.
NOTE In this position the jack allows
you to raise the entire front axle.
To Next Page
Loading...
