embrace Wave+ - Alarm Setup

21
Blood Glucose Monitoring System
Begin testing by inserting a Embrace
®
WAVE Blood Glucose Test Strip (see Testing Your
Blood Glucose on page 31), or press and hold “
” to turn off the meter, or continue to set
up the alarm feature on your meter.
NOTE:
• If you do not set the date and time on the Embrace
®
WAVE+ Blood Glucose Meter, the
test or control results will not be stored in the meter’s memory.
• Anytime during setup, you can insert a Embrace
®
WAVE Blood Glucose Test Strip to
begin testing. Any changes made so far will be stored.
• You may need to reset time after changing batteries.
Alarm Setup
You can set up to three alarms on the Embrace
®
WAVE+ Blood Glucose Meter. The feature
is to remind you when to perform a (blood glucose) test. You must set the clock before
setting the alarms. When the alarm reaches the set time, the meter sounds for 30 second.
Pressing “
” or inserting a test strip will silence the alarm.
CAUTION:
• Before setting the alarms please check that the time is properly set.