Installing a standalone DS-300B
25
Installing and Configuring the DS-300B
Installing a standalone DS-300B
To install the DS-300B as a standalone unit:
1. Unpack the DS-300B and verify the items listed on “Items
required for installation” on page 24.
2. Apply the adhesive rubber feet. Applying the rubber feet onto the
switch helps prevent the switch from sliding off the supporting
surface.
a. Clean the indentations at each corner of the bottom of the
switch to ensure that they are free of dust or other debris that
might lessen the adhesion of the feet.
b. With the adhesive side against the chassis, place one rubber
foot in each indentation and press into place.
3. Place the switch on a flat, sturdy surface.
4. Provide power to the switch as described in“Powering the
DS-300B on and off” on page 36 .
Note: Do not connect the switch to the network until the IP address is
correctly set. For instructions on how to set the IP address, see “Configuring
the DS-300B” on page 28.